Skip to main content

Testing Smart Contracts

Testing of smart contracts happens in the Solo testing environment. This enables synchronous, deterministic testing of smart contract functionalities without the overhead of having to start nodes, set up a committee, and send transactions over the Tangle. Instead, you can use Go's built-in test environment in combination with Solo to deploy chains and smart contracts and simulate transactions.

Solo directly interacts with the ISC code, and therfore uses all the ISC-specific data types directly. Our Wasm smart contracts cannot access these types directly, because they run in a separate, sandboxed environment. Therefore, WasmLib implements its own versions of these data types, and the VM layer acts as a data type translator between both systems.

The impact of this type transformation used to be that to be able to write tests in the solo environment the user also needed to know about the ISC-specific data types and type conversion functions, and exactly how to properly pass such data in and out of smart contract function calls. This burdened the user with an unnecessary increased learning curve and countless unnecessary type conversions.

With the introduction of the Schema Tool, we were able to remove this impedance mismatch and allow the users to test smart contract functionality in terms of the WasmLib data types and functions that they are already familiar with. To that end, we introduced SoloContext, a new Call Context that specifically works with the Solo testing environment. We aimed to simplify the testing of smart contracts as much as possible, keeping the full Solo interface hidden as much as possible, but still available when necessary.

The only concession we still have to make is to the language used. Because Solo only works in the Go language environment, we have to use the Go language version of the interface code that the Schema Tool generates when testing our smart contracts. Because WasmLib programming for Go, Rust, and TypeScript are practically identical, we feel that this is not unsurmountable. The WasmLib interfaces only differ slightly if language idiosyncrasies force differences in syntax or naming conventions. This hurdle used to be a lot bigger, when direct programming of Solo had to be used, and most type conversions had to be done manually. Now we get to use the generated compile-time type-checked interface to our smart contract functions that we are already familiar with.

Let's look at the simplest way of initializing a smart contract by using the new SoloContext in a test function:

func TestDeploy(t *testing.T) {
ctx := wasmsolo.NewSoloContext(t, dividend.ScName, dividend.OnDispatch)
require.NoError(t, ctx.ContractExists(dividend.ScName))

The first line will automatically create a new chain, and upload and deploy the provided example dividend contract to this chain. It returns a SoloContext for further use. The second line verifies the existence of the deployed contract on the chain associated with that Call Context.

Here is another part of the dividend test code, where you can see how we wrap repetitive calls to smart contract functions that are used in multiple tests:

func dividendMember(ctx *wasmsolo.SoloContext, agent *wasmsolo.SoloAgent, factor uint64) {
member := dividend.ScFuncs.Member(ctx)

func dividendDivide(ctx *wasmsolo.SoloContext, amount uint64) {
divide := dividend.ScFuncs.Divide(ctx)

func dividendGetFactor(ctx *wasmsolo.SoloContext, member *wasmsolo.SoloAgent) uint64 {
getFactor := dividend.ScFuncs.GetFactor(ctx)
value := getFactor.Results.Factor().Value()
return value

As you can see, we pass the SoloContext and the parameters to the wrapper functions, then use the SoloContext to create a Function Descriptor for the wrapped function, pass any parameters through the its Params proxy, and then either post() the function request or call() the function. Any results returned are extracted through the descriptor's Results proxy, and returned by the wrapper function.

There is hardly any difference in the way the function interface is used within Wasm code or within Solo test code. The Call Context knows how to properly call() or post() the function call through the function descriptor. This makes for seamless testing of smart contracts.

In the next section we will go deeper into how the helper member functions of the SoloContext are used to simplify tests.